Table of Contents
Advertisement
Appliance door
en
Removing and refitting the door panels
The glass panels can be removed from the oven door
to allow more thorough cleaning.
Removal
Removing the oven door See the section
1.
. Lay the oven door on a cloth with the
the oven door
handle facing downwards.
Remove the cover from the top of the oven door. To
2.
do this, press with your fingers on the left and right-
hand side. Pull out the cover (Fig. A).
Raise the top panel and pull it out (Fig. B).
3.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting
Hold the top glass panel firmly by the sides and slide
1.
it in towards the back at an angle. The panel must
be inserted into the openings on the lower side. The
smooth surface must face outwards, while the
roughened side must be on the inside. (Fig. A).
Place the cover on the top of the oven door and
2.
press in place. Make sure that the grooves along the
sides lock into position.
Refitting the oven door See the section
3.
.
oven door
Do not use the oven again until the panels have been
correctly fitted.
28
Additional door safety
When preparing meals with long cooking times, the
oven door can reach very high temperatures.
Supervise small children and keep them away from the
oven when the oven is in operation.
Additional safety devices have been fitted to prevent
Removing
contact with the oven door. Always attach these safety
devices when children could come near the oven.
You can purchase this optional accessory (11023590)
from the after-sales service.
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
:
A scratched glass cover may break and fragment. Do
not use glass scrapers, sharp or abrasive cleaning aids,
or harsh cleaning products.
Refitting the
Warning – Risk of injury!
Advertisement
Table of Contents
