Table of Contents
Advertisement
Components
1. Cord
2. Clip
3. Engine shut-off switch
EMU26090
Main switch
The main switch controls the ignition system;
its operation is described below.
"
" (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
" (on)
G
With the main switch in the "
the electrical circuits are on, and the key can-
not be removed.
"
" (start)
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
OFF
26
ON
ON
OFF
START
OFF
START
3
2
1
ZMU05818
" (off) posi-
" (on) position,
" (start) po-
" (on) position.
ON
START
ZMU04567
ON
OFF
START
EMU32052
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pressing the switch "
board motor up, and then tilts it up. Pressing
the switch "
" (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position. For instructions on using the
power trim and tilt switch, see pages 57 and
59.
UP
DN
EMU26153
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on the
side of the bottom engine cowling. Pressing
the switch "
" (up) trims the outboard motor
up, and then tilts it up. Pressing the switch
"
" (down) tilts the outboard motor down and
ON
OFF
START
ZMU05821
" (up) trims the out-
ZMU03938
Advertisement
Table of Contents
