Desciption Of Function & Circuit Of Micom - Kenmore 795.74092.41 Series Service Manual

13. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
13-1 FUNCTION
13-1-1 Function
When the appliance is plugged in, default set values are 37°F for Refrigerator and 0°F for freezer.
You can adjust Refrigerator and Freezer control temperature by pressing ADJUST button on display
1. When the power is initially applied or restored after a power failure, it is set to Control temperature Previously.
2. Top display is turned on when the door is left open. dispenser panel is always turned on the water, cube, crush, lock Icon
that has been selected.
13-1-2 How to Toggle the Display between °F & °C
1. The initial setting is °F and the display temperature mode can be converted °F to °C or °C to °F by pressing and holding
Freezer Temperature Button and Refrigerator Temperature Button at the same time for over 5 seconds.
13-1-3 Control Lock function (dispenser and display button lock)
1. When refrigerator is firstly turned on, the buttons are not locked.
"Control Lock" is deactivated.
2. To lock the display, the dispenser and the control panel, press and hold the
control lock buttons for 3 seconds.
"Control Lock" is activated.
3. The Control Lock button is the only control feature that remains active in the
locked state. The buzzer sound, other control buttons and the dispenser are
deactivated.
4. To release from the locked state, press and hold the Control Lock button again
for 3 seconds.
13-1-4 Door Alarm function
1. When refrigerator is firstly turned on, "Door alarm" is activated.
2. When you press the Door Alarm button, the display will change to OFF and
the Door Alarm function will deactivate.
3. When either the refrigerator or the freezer door is left open for more than 60
seconds, the alarm tone will sound to let you know that the door is open.
4. If you close the door, the door alarm will stop.
13-1-5 Water Filter condition display function
1. There is a replacement indicator light for the water filter
cartridge.
2. Water filter needs replacement every six months for
using water filter.
3. When the CHANGE icon lights on, you must exchange
the filter.
4. After replacing the filter, press and hold the water filter
reset button for 3 seconds .
After then water Filter icon turn off with reset status
Ex) In selecting
Ex) In selecting
In initial Power On
Classification
/ Filter RESET
Filter Status
Display
- 99 -
Ex) In selecting
"LOCK" "LOCK" again
Ex) In selecting
"Alarm" "Alarm" again
On