Required Tools And Equipment For Installation And Maintenance - Cisco 3800 Series Quick Start Manual

Required Tools and Equipment for Installation and Maintenance

Required Tools and Equipment for Installation and Maintenance
You need the following tools and equipment to install and upgrade the router and its components:
•
•
•
•
•
•
•
•
Preinstallation Requirements and Planning for Cisco 3800 Series Routers
8
Number 1 and number 2 Phillips screwdrivers
Equipment rack and screws to attach router mounting brackets to the rack
Wire and wire-crimping tool for connecting the router chassis to earth ground
2
– AWG 6 (13 mm ) wire for NEBS-compliant chassis grounding
–
2
– AWG 14 (2 mm ) or larger wire for NEC-compliant chassis grounding
–
2
– AWG 18 (1 mm ) or larger wire for EN/IEC 60950-compliant chassis grounding
–
For NEC-compliant grounding, a ring terminal with an inner diameter of 1/4 inch (5 to 7 mm)
Cables for connection to WAN and LAN ports
Note For information on cables and cable specifications for WAN and LAN ports on network
modules and interface cards, refer to the
Guide, the Cisco Interface Cards Installation
Cable Specifications.
Console (ASCII terminal or PC running HyperTerminal or similar terminal emulation software)
configured for 9600 bps, 8 data bits, no parity, and 1 stop bit
Modem for remote administrative access (optional)
ESD-preventive cord and wrist strap for procedures that require access to internal components
Cisco Network Modules Hardware Installation
Guide, and the Cisco Modular Access Router
OL-5967-01