Connecting Routers To The Cisco Redundant Power System; Connecting Wan, Lan, And Voice Cables; Ports And Cabling - Cisco 3700 Series Hardware Installation Manual

Connecting WAN, LAN, and Voice Cables

If your router has a second power supply installed, repeat
Step 8
supply.
Turn on power to the DC circuit.
Step 9

Connecting Routers to the Cisco Redundant Power System

If your router uses the Cisco Redundant Power System (RPS), see the
Guide
described in the
Connecting WAN, LAN, and Voice Cables
This section describes how to connect the WAN, LAN, and voice interface cables. It includes the
following topics:
•
•
One or two Ethernet cables are typically provided with the router. Additional cables and transceivers can
Note
be ordered from Cisco. For ordering information, see the
http://www.cisco.com/en/US/products/products_catalog_links_launch.html. For cable pinouts, see the
Cisco Modular Access Router Cable Specifications
Warning Do not work on the system, or connect or disconnect cables during periods of lightning activity.
Statement 1001

Ports and Cabling

Table 3-3
The connections summarized here are also described in detail in the following documents:
•
•
•
You can access these documents at the location described in the
page
Cisco 3700 Series Routers Hardware Installation Guide
3-20
for instructions about the power connections. You can access this document at the location
"Obtaining Documentation" section on page
"Ports and Cabling" section on page 3-20
"Connection Procedures and Precautions" section on page 3-21
summarizes some typical WAN, LAN, and voice connections for Cisco 3700 series routers.
Cisco Modular Access Router Cable Specifications
Cisco Network Modules Hardware Installation Guide
Cisco Interface Cards Hardware Installation Guide
xvi.
Chapter 3
Step 1 through Step 7
Cisco RPS Hardware Installation
xvi.
Cisco Product Catalog
document available on Cisco.com.
"Obtaining Documentation" section on
Installing the Router
for the second power
at
OL-2180-08