Installation - Qilive Q.6598 Instruction Manual

5. INSTALLATION

WARNING! Electrical shock hazard. Disconnect
electrical power before installing the appliance. Failure
to do so could result in death or electrical shock.
ATTENTION!
The installation of the pipes and electrical equipment
should be done by professionals.
5.1. Power connection
Look at the rating label to know the rating voltage and connect the appliance to the appropriate power
supply. Use the required fuse
and provide separate circuit serving only this appliance.
5.2. Water supply and drain
Cold water connection
1
( Fig. C: = Ordinary supply hose /
■ Connect the cold water supply hose to a threaded ¾" connector and make sure that it is
fastened tightly in place.
■ If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure that the water is clear. This precaution is needed to avoid the risk of the water
inlet to be blocked and damage the appliance.
■ Safety supply hose: The safety supply hose consists of double walls. The hose's system
guarantees its intervention by blocking the flow of water in case of the supply hose breaking
and when the air space between the supply hose itself and the outer corrugated hose is full
of water.
WARNING!
■ A hose that attaches to a sink spray can burst if it is
installed on the same water line as the appliance.
If your sink has one, it is recommended that the
hose be disconnected and the hole plugged.
How to connect the safety supply hose
■ Pull the safety supply hoses completely out from storage compartment located at rear of the
appliance.
■ Tighter the screws of the safety supply hose to the faucet with thread ¾".
■ Turn water fully on before starting the appliance.
How to disconnect the safety supply hose
■ Turn off the water.
■ Unscrew the safety supply hose from the faucet.
5.3. Connection of drain hoses
( Fig. D).
■ Insert the drain hose into a drain pipe with a minimum diameter of
sink, making sure to avoid bending or crimping it. The height of drain pipe must be less than
1000 mm. The free end of the hose must not be immersed in water to avoid the back flow of it.
■ Securely fix the drain hose in either position
10 A / 13 A / 16 A, time delay fuse or circuit breaker recommended
2
= Safety supply hose)
1 or position 2.
17
40 mm, or let it run into the