Trouble-Shooting Answer To Questions - Haier XPB60-CS User Manual

Trouble-shooting Answer to questions

If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub
If the laundries fall to the outer side of the spin tub, If the laundries fall to the outer side of the spin tub,
please take them out immediately. please take them out immediately.
1.Dismantle 1.Dismantle
As indicated in the figure, push the point marked As indicated in the figure, push the point marked
with " " to pull the spin tub frame to oblique with " " to pull the spin tub frame to oblique
upwards to dismantle it. upwards to dismantle it.
2.Install 2.Install
After install the back edge of the spin tub frame to After install the back edge of the spin tub frame to
proper position, push the four points marked with proper position, push the four points marked with
" " by force to reset it. " " by force to reset it.
Please check carefully. The laundries may fall to the
lower part of the outer side of the spin tub (as
indicated in the figure).
If the laundries fall to the outer side of the spin
tub, during spinning the draining will get blocked
and the rotation speed of the spin tub is reduced.
When the remaining water is frozen
Prevent the freezing (be sure to discharge the water completely
after using)
After complete draining, set the "WASH SELECTOR" at "STRONG"
or "STANDARD". If it is set at "DRAIN", it will be rather difficult for
the frozen water to melt.
When the water is frozen
Pour hot water below 50 into the
wash tub to soak it completely.
Then turn the pulsator on gently.
Please confirm the drainage can
work normally before using again.
Spin tub Spin tub
15
Spin tub frame Spin tub frame
Laundries Laundries
Below 50 c Below 50 c
2~3L 2~3L