Related Manuals for Haier XPB70-0713S
Summary of Contents for Haier XPB70-0713S
- Page 1 Twin-tub Washing Machine User's manual This manual is for XPB70-0713S Please read this manual carefully before using. Retain it for future reference.
-
Page 2: Table Of Contents
Contents Names of the parts - - - - - - - - - - - - - - - - - 1 Safety precautions - - - - - - - - - - - - - - - - - 2 Installation and adjustment - - - - - - - - - - - 4 Preparation before washing - - - - - - - - - - 6 The musts in washing - - - - - - - - - - - - - - - 7... -
Page 3: Names Of The Parts
Names of the parts Wash selector Wash timer Outer cover of the spin tub Water-filling entrance Inner cover of the spin tub Control panel Spin timer Overflow filter Major frame Water level adjusting lever Spin tub Wash tub Lint filter Protecting cover installed by user Cabinet... -
Page 4: Safety Precautions
Safety precautions Please insert the power cord into When the machine is normally special receptacle with rated vol- using, please put the power plug tage. Be sure to use single-phase at the location easily to be insert- three pins receptacle. The earthing ed and extracted by hand. - Page 5 Safety precautions Do not stretch hands into the working Do not decompose, repair or alter the machine. It is dangerous even if the machine by yourself. rotation is slow. Take special care of the children. Do not put any hot or heavy items Do not wash laundries with volatile ( such as the kettle with hot water ) materials (such as thinner, petrol etc.).
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the lint filter After opening the package, please take out the lint filter from the document bag, install it to the overflow filter of the wash tub. -
Page 7: How To Change The Direction Of The Drain Hoses
How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Back Soft item Extend the drain hose from the side of spin tub Front Put soft items on the ground. Lean the machine down gently with the front surface facing the Figure 1 ground. -
Page 8: Preparation Before Washing
Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose . -
Page 9: The Musts In Washing
The musts in washing The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. -
Page 10: Washing Sequence
Washing sequence Wash timer Wash selector Spin timer Water inlet (To set to below 2 minute, (standard current, (to set to below 1 minute, first set to 6 minute then strong current) first set to 2 minute then turn it back. it can increase turn it back. -
Page 11: Rinse With Water-Filling
Rinsing Rinse with water-filling 1.Put the laundries into the wash tub. Select suitable current according to the laundries. 2.Adjust the water level Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Rinse Adjust the wash timer to 5-7 minutes to do rinsing. - Page 12 Ï ´ µ Ó Ð ë Ö ª Spinning 1.Put the laundries into the spin tub evenly and smoothly. 2.Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland Push Proper...
-
Page 13: Disposal After Washing
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. -
Page 14: Cleaning The Overflow Filter
Cleaning the overflow filter 2. Take off the corrugation pipe. Water level Dismantle the upper part of the adjusting lever corrugation pipe inside Corrugation overflow filter ( as indicated in Pipe Figure 1). 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. -
Page 15: Trouble-Shooting Answer To Question
Disposal of the complete unit After washing, dismount the water inlet Wipe the complete unit with soft hose. cloth twisted dry. Do not store water in the tub for long period. Discharge the water immediately Wipe with neutral detergent if too dirty. after each using. - Page 16 Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
-
Page 17: Packing List
Packing list Quantity Name One piece User's manual One piece Water inlet hose One piece Lint filter One piece Gland One set Twin-tub washing machine... -
Page 18: Specification
Specification Water level/Water quantity (L) (about) Maximum/48 Medium/39 Minimum/33 Injection pressure(MPa) 0.02 0.2 Washing capacity(kg) Spinning capacity(kg)