Installations - LG MC-806CLR Service Manual

BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
Installing microwave oven
1. Empty the microwave oven and clean inside it with a
soft, damp cloth. Check for damage such as
misaligned door, damage around the door or dents
inside the cavity or on the exterior.
2. Put the oven on a counter, table or shelf that is
strong enough to hold the oven, food and utensils
you put in it. (The control panel side of the oven is
the heavy side. Use care when handling.)
3. Do not block the vent and the air intake openings.
Blocking vent or air intake openings can cause
damage to the oven and poor cooking results.
Make sure the microwave oven legs are in place to
ensure proper air flow.
4. The oven should not be installed in any area where
heat and steam are generated, because they may
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.
5. Use the microwave oven in an ambient temperature
of less than 104°F (40°C).
6. Place the microwave oven on a sturdy and flat
surface, at least 10cm(4 inches) from the wall.
7. Place the microwave oven as far away as possible
from TV, RADIO, COMPUTER etc, to prevent
interference.
8. This oven must be plugged into a 15A outlet.
9. Do not touch the front glass during or after cooking
of the Grill, Convection and Combination mode.
This glass is very hot during heater operating.
10. Do not operate oven at microwave and combination
mode with the Convection rack or Grill rack placed
in the cavity when the oven is empty.

INSTALLATIONS

Earthing Instructions
This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing.
WARNING-
THIS APPLIANCE
MUST BE EARTHED
IMPORTANT
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows.
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol (b ) or coloured
green or green-and yellow.
The wire which is coloured blue must be connected to
the terminal in the plug which is marked with the letter N
or coloured black.
The wire which is coloured brown must be connected to
the terminal in the plug which is marked with the letter L
or coloured red.
* Power cord type: "Y" Type
3-1
The wires in this mains lead are coloured in
accordance with the following code:
Green-and-yellow:
Blue:
Brown:
Earth
Neutral
Live