Table of Contents
Advertisement
J. TURNTABLE MOTOR REMOVAL
1) Remove the turntable.
2) Remove the turntable shaft VERY CAREFULLY with
a slotted screw driver.
3) Lay the set down on its back.
4) Remove the turntable motor cover. The turntable
motor base cover is easily removed by pinching the
six parts with a wire cutting.
5) Disconnect the lead wires from the turntable motor
terminals.
6) Remove two screws securing the turntable motor to
the oven cavity assembly.
7) Lift the turntable motor and mount turntable motor.
8) After repairing the motor, fit the turntable motor
cover's projecting part to the base plate's slit.
K. INTERLOCK SYSTEM
1) INTERLOCK MECHANISM
The door lock mechanism is a device which has been
specially designed to completely eliminate microwave
activity when the door is opened during cooking and
thus to prevent the danger resulting from the
microwave leakage.
2) MOUNTING OF THE PRIMARY, MONITOR AND
SECONDARY SWITCH TO THE LATCH BOARD
ADJUSTMENT
DIRECTION
PRIMARY
SWITCH
MONITOR
SWITCH
SECONDARY
SWITCH
3) INSTALLATION AND ADJUSTMENT OF THE
LATCH BOARD TO THE OVEN ASSEMBLY
• Mount the latch board to the oven assembly.
• Adjust the latch board in the arrow direction so the
oven door will not have any play in it when the door is
closed.
• Tighten the mounting screw.
• Check for play in the door by pushing the door
release button. Door movement should be less than
0.5mm. (1/64inch)
Don't push the door release button while making
adjustment. Make sure that the latch moves smoothly
after adjustment are completed and that the screws
are tight. Make sure the primary/monitor/secondary
switch operate properly by following the continuity
test procedure.
5-7
Advertisement
Table of Contents
