Advertisement
FEATURE PROGRAMMING:
FEATURE "A" PROGRAMMING:
1.
Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3rd push) until one chirp with a long
chirp is heard, then release the valet switch. You are now in the Alarm feature 'A'
programming mode.
3.
Press and release the transmitter button corresponding to the feature you want to
program. (See chart on next page)
The siren chirps and LED pause will indicate new setting.
The factory default settings are always [1] LED flash, [1] siren chirp.
4.
Press the transmitter button to change the feature.
transmitter button again until the module advances to your desired setting.
a.
In this case, Press the button again, the module will advance
to [2] LED flash, [2] horn chirp.
b.
Press the button again; the module will advance to [3] LED flash, [3] horn chirps etc.
One Chirp /
Press
LED one pulse
Transmitter
Factory Default
Button
Setting
1
Active arming
2
Automatic Rearm
off
Instant Door Ajar
3
error chirp
Siren Confirmation
4
chirp on only
H3/2 White wire=
5
+
Dome Light
Output
Lock/Arm &
6
+
Unlock/Disarm
Confirmation
Chirps
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
Simply continue pressing the
Three Chirps /
Two Chirps /
LED three
LED two pulses
pulses
Passive arming
Passive arming
without passive
with passive
door locking
door locking.
Automatic Rearm
on
45 seconds delay
Door Ajar error
chirp.
Horn
All Confirmation
Confirmation
chirps On
chirp on only
H3/2 White wire=
H3/2 White =
rd
rd
3
Channel
3
channel
Momentary
Latched
Lock/Arm
Confirmation
Chirp Only
8
Four Chirps /
LED four
pulses
All
Confirmation
chirps off
Advertisement
