Advertisement
2 STEP DOOR UNLOCK WIRE CONNECTION FOR
POSITIVE SWITCHED DOOR LOCKS
+12V
6-Pin
H3/8
Plug
Gray Wire
From
Alarm
H7/3 Green Wire
Door Lock
H7/1 Blue
Wire
Door Unlock
OEM Driver's
Door Lock
Motor
Note: This system can keep up to 4 remote transmitters in its memory. If more than 4
transmitters programmed, the system will keep only the last 4 transmitters.
PROGRAMMING THE REMOTE TRANSMITTER
Enter:
1. Turn the Ignition 'switch 'OFF/ON' 3 TIMES and stay in ON position. Within 15 seconds.
2. Push the Valet switch 2 times. (Holding in on the 2nd push) until you hear a long chirp.
The transmitter is ready to program.
Program:
1.
Press any button on
the transmitter until the siren responds with a confirming chirp
the first transmitter is now programmed.
2.
Press button on the second transmitter until the siren responds with a confirming
chirp, the second transmitter is now programmed.
Apply the same procedure to program 3rd and 4th .
3.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. A 3 long chirps & 3 parking
light flashes to confirm exit.
OEM Door Master Lock Switch
87
Unlock
86
85
87A
Existing Pos.
30
Unlock Wire
+ 12V
87
87A
+ 12V
85
86
30
+ 12V
OEM Door
Lock Relay
87
87A
85
86
30
X
Cut Existing Unlock
PROGRAMMING:
7
Lock
Existing Pos.
Lock Wire
To All Other
Door Lock
Motors
Advertisement
