Configuring The Ethernet Or Token Ring Interfaces - Cisco 2524 Configuration Manual

The ISDN BRI interface is configured to allow connection to ISDN WANs. To configure
the ISDN BRI interface, respond as follows (using your addresses and subnet mask) to the
setup prompts, substituting the correct addresses and host names as appropriate:
Configuring interface BRI0:
Is this interface in use? [yes]
Configure IP on this interface? [yes]
IP address for this interface: 172.16.71.1
Number of bits in subnet field [0]: 8
lass B network is 172.16.0.0, 8 subnet bits; mask is
Configure AppleTalk on this interface? [no]: yes
Configure IPX on this interface? [no]: yes
Configuring the Ethernet or Token Ring Interfaces
Take the following steps to configure the Ethernet or Token Ring interface to allow
communication over a LAN. To configure the interface parameters, you need to know your
Ethernet or Token Ring interface network addresses. In this example, the system is being
configured for an Ethernet LAN using IP.
Step 1
255.255.255.0
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 1
AppleTalk ending cable range [1]: 2
AppleTalk zone name [myzone]:
AppleTalk additional zone name: otherzone
AppleTalk additional zone name:
IPX network number [1]: B000
Respond as follows (using your addresses and subnet mask) to the setup prompts,
substituting the correct addresses and host names as appropriate:
Configuring interface Ethernet0:
Is this interface in use? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.72.1
Number of bits in subnet field [8]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configuring the Cisco 2524 and Cisco 2525 Routers 4-11
Configuring the Router