Table of Contents
Advertisement
If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM
to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on page 12.
Be sure to save your configuration changes occasionally so that they are not lost during resets, power cycles, or power
Note
outages. Use the copy running-config startup-config command at the privileged EXEC mode prompt (Router#) to save
the configuration to NVRAM.
To proceed with manual configuration using the CLI, enter no when the power-up messages end.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration.
Step 2
Would you like to terminate autoinstall? [yes] Return
Several messages appear, ending with a line similar to the following:
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Step 3
Press Return to display the Router> prompt.
...
flashfs[4]: Initialization complete.
Router>
Enter privileged EXEC mode.
Step 4
Router> enable
Router#
For configuration using the CLI, refer to the applicable configuration procedures in the Cisco 1700 Router Software
Step 5
Configuration Guide documentation at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1800/sw/index.htm
Verify the initial configuration. See the "Verifying the Initial Configuration" section on page 13 for verification
Step 6
procedures.
Verifying the Initial Configuration
To verify that the new interfaces are operating correctly, perform the following tests:
• To verify that the interfaces are operating correctly and that the interfaces and line protocol are in the correct state—up or
down—enter the show interfaces command.
• To display a summary status of the interfaces configured for IP, enter the show ip interface brief command.
• To verify that you configured the correct host name and password, enter the show configuration command.
• To identify the port numbers of voice interfaces installed in your router enter the show voice port command:
Router# show voice port slot-number/port-number
As an example of voice port numbering, if you installed VICs in both slot 1 and slot 2 of the router, the ports in each of
these slots would be numbered as follows:
Slot 1—1/0 and 1/1
Slot 2—2/0 and 2/1
When you have completed and verified the initial configuration, your Cisco router is ready to configure for specific functions.
Configuring the Router Using the Cisco IOS CLI
13
Advertisement
Table of Contents
