Trouble Shooting Answer To Question - Haier HWM60-728 User Manual

Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena
are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real
breakdowns, please come to the specialmaintenance department or after-sale service department
of our company. Do not repair it by yourself.
Phenomenan
The digitron displays E0.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2.
The safety switch acts, and the spin-
ning cannot work. Amend twice
automatically ,The digitron displays E3.
The water filling does not work, or is
slow. The digital displays E4.
The digitron displays E6.
Not wash
The machine does
not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the "spin" button to select "Spin",
but it doesn't work.
There may be some water flowing out of
the drain hose in the first use of the machine.
The wash procedure is paused
The pulsator pauses during water inlet in wash
and rinse.
When the power plug is inserted, computer
board indicator is switched on, and the machine
starts working
The reason
The top lid is open during reserve
procedure.
Is the drain hose put down?
Is the drain hose blocked?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
It is the water remained in the factory inspection
of performance.
The cloth sensor is checking the cloth, it will add
water after 48 seconds.
It is to avoid splashing during water inlet.
It is the special resume function. In the case of power failure
or the power plug is loose during washing, the machine can
save the running program, and resume the program after
the power supply is recovered. You do not need to set the
program again.
16
How to settle
Close the top lid.
Put down the drain hose. Open and close the
top lid once.
Clean the foreign material. Open and close
the top lid once.
Close the top lid.
Reorder the laundries. Close the top lid.
Place the machine horizontally, open
and close the top lid once.
Open the water tap. Open and close the
top lid once.
Clean the water inlet valve then open and
close the top lid once.
Use after the water pressure is normal.
Please contact the after-sales
service department.
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Level the machine properly.
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
Explanation