Washing Sequence - Haier DWE-270 User Manual

Washing sequence

Wash timer Wash selector
(To set to below 2 minute, (gentle current,
first set to 5 minute then standard current)
turn it back. it can increase
the service life of the timer).
OFF
GENTLE
WASH
SOAK
WASH SELECTOR
WASH TIMER
Wash
1.Water-filling selector
(1) Set the water-filling selector at the "WASH" side.
(Figure 1)
(2) Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the" STANDARD" or "GENTLE "current
according to the laundries. (Figure 3)
4.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
Remarks:
1. 0~15 minute is the normal soaking.
2. 15~45 minute is active soaking. During active soaking, the pulsator will run for 2 minutes
in each 8 minutes. After the active soaking, it will run normal washing for 15 minutes.
3. If you select soaking(i.e. turn the knob to position between 15~45 minutes), be sure to
dissolve the washing powder in advance, otherwise the washing powder may result in
damage to the laundries.
5.After washing, the buzzer alarms. Set current change
at "DRAIN"position. (Figure 5).
Water-filling entrance
STANDARD
DRAIN
Overfilling sign
Buzzer
(The buzzer will ring when
the washing finishes)
OFF
MAX
BUZZER
GENTLE
WASH SELECTOR
WASH TIMER
WASH SELECTOR
Using process
Using process
Water-filling selector handle
Spin timer
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
OFF
SPIN TIMER
SPIN
WASH
Figure 1
Figure 2
STANDARD
DRAIN
Figure 3
OFF
WASH
SOAK
Figure 4
STANDARD
GENTLE
DRAIN
Figure 5