Table of Contents
Advertisement
Cleaning the filter frame
2. Take off the corrugation pipe.
Dismantle the upper part of the
corrugation pipe
overflow filter (See to Figure 1).
3. Cleaning the filter frame
Clean the lint around the frame
and flush with tap water.
4. Install the filter frame.
(1).Install the corrugation pipe.
(2).Insert the mounting plate at
the bottom of the frame into
the valve cover.
(3).Hang up the hook at the left
upper side.
(4).Push the upper part in as
indicated in Figure 2.
Disposal of the complete unit
Wipe the complete unit with soft cloth
twisted dry.
Wipe with neutral detergent if too dirty
Do not wash it directly by water
Alcohol
inside
the
Thinner
Petrol
Using process
Using process
Water level
adjusting lever
Figure 1
Hook
Figure 2
After washing, dismount the water inlet
hose.
Do not store water in the tub for long
period. Discharge the water immediately
after each using.
Pull off the power plug and hang up the
power cord.
Hang up the drain hose.
Wipe off the water drops on the surface
and inside the tub with clean soft cloth.
Open the cover of the wash tub and the
inner/outer cover of the spin tub for
some time (about one hour), then close
them.
Corrugation
Pipe
Advertisement
Table of Contents
