Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are
not breakdowns sometimes. Please confirm again before sending it to repair. If there are real
breakdowns, please come to the special maintenance department or after-sale service department of
our company. Do not repair it by yourself.
Phenomenan
After the reserve is started, it rings and the
digital tube displays E0
The draining does not work ,or the speed of
draining is too slow. The digital tube displays
E1 and it rings.
It stops running during spin .the digital
tube displays E2 and it rings.
The safety switch acts. The spinning
can not work (after twice revising)
The digital tube shows E3 and it rings.
It does not do water inlet or the speed
is slow ( the water level is not reached
after 40 minutes). The digital tube
displays E4 and it rings.
the machine does
No wash
not act . (The
indicators are off.)
No spin
There's abnormal sound inside
the machine.
The water faucet leaks.
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Pause during washing
Push the PROSESS button to select SPIN, but it
doesn't act.
The pulsator pauses during water filling in washing and rinsing.
There may be some water flowing out of the drain
hose in the first use of the machine.
The reason
*
The top lid is not closed.
*
Is the drain hose put down?
*
Is the drain hose blocked by
foreign material?
The top lid is not closed.
*
*
Are the laundries put slantingly?
*
Is the machine slanting?
*
Is the water faucet open or is there water
supply failure?
*
Is the water inlet valve blocked.
Is there power failure?
*
Is the power plug loose?
*
If water level reach the appoint level?
*
Is the power plug loose?
*
*
Is the top lid is not closed.?
Are the laundries put slantingly?
*
*
Is the machine slanting?
Is there metal material inside the
*
washing machine?
Are the laundries slanting in spinning?
*
*
Is the jointer screw of the water inlet
hose loose or twisted awry?
How to settle
*
Close the top lid.
Put down the drain hose.
*
Open and close the top lid once.
*
Clean the foreign material .
Open and close the top lid once.
*
Close the top lid.
*
Re-order the laundries. Close the top lid.
*
Level the machine in right position.
Open and close the top lid once.
Open the water faucet.
*
Open and close the top lid once.
Clean the water inlet valve .
*
Open and close the top lid once.
*
Use it when the power is on.
Insert the power plug tightly.
*
*
Affusion to appoint level.
Insert the power plug tightly.
*
Close the top lid
* *
Re-order the laundries. Close the top lid.
*
Level the machine properly.
*
Fasten the fastener or zip up the zip.
Re-order the laundries. Close the top lid.
*
Fasten the jointer screw properly.
*
Explanation
It is to balance the laundries to avoid slanting.
Supplemental water filled after fabric sensor
has checked fabric(about 48 seconds).
The program is setting the drain time. A certain
period is needed before it starts spinning.
It is to avoid splashing during water filling.
It is the water remained in the machine during the
ex-factory performance inspection.
Advertisement
Table of Contents
