Bosch Bulldog GBH18V-28DC Operating/Safety Instructions Manual page 12

2610056669 GBH18V-28DC 08-21_GBH18V-26D 8/30/21 9:19 AM Page 12
Connectivity Module
Installation (sold separately)
operating instructions included with
Bosch connectivity module. Operating
instructions for connectivity module
include important information not
covered in this manual.
If connectivity module is not purchased
with the tool, or if the replacement of
the module or the battery becomes
necessary, please follow this procedure
(See Fig. 8):
- Using a flat screwdriver or a coin,
remove the cover A from the side of
the handle, by turning it 1/4 turn
counter-clockwise (Fig. 8 or 9).
- If the tool is already equipped with
the connectivity module, remove the
battery B, but do not remove the
connectivity module C.
- If the connectivity module is installed
for the first time, remove the plastic
placeholder D from the connectivity
module compartment, and place the
connectivity module C in the
compartment observing correct
orientation (Fig. 9). Note: Store the
placeholder D in a safe place.
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery B on the top
of the connectivity module with the
"+" polarity facing up (Fig. 8).
- Place the cover A over the battery
and turn it ¼-turn clockwise to lock
using a flat screwdriver or a coin.
Operating Instructions
To reduce the risk of
injury read the
-12-
Fig. 8
Fig. 9
A
B
C
A
D