Bosch Bulldog GBH18V-28DC Operating/Safety Instructions Manual page 10

2610056669 GBH18V-28DC 08-21_GBH18V-26D 8/30/21 9:19 AM Page 10
accessories. Such preventive safety measures reduce the risk of starting the tool
accidentally.
Inserting and Releasing
Battery Pack
Set Forward/Reversing lever to the
center (locked position). Slide charged
battery pack into the housing until the
battery pack locks into position (Fig. 2).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the
handle, should it become loose due to
vibration.
To remove the battery pack, press the
battery pack release button and slide
the battery pack completely out of tool
housing (Fig. 2).
Installing SDS-plus® Accessories
Clean the insert shank end of the
accessory to remove any debris, then
lightly grease with a light oil or
lubricant.
Insert accessory into the chuck through
the dust shield, while twisting and
pushing inward
automatically into place. Pull outward
on the accessory to be certain it is
locked into the chuck (Fig. 3).
NOTE: The high efficiency available
from the rotary hammers can only be
obtained if sharp and undamaged
accessories are used. The "cost" to
maintain sharp
accessories is more than offset by the
"time saved" in operating the tool with
sharp accessories.
Removing SDS-plus®
Accessories
contact with skin and use proper
protective gloves or cloth to remove.
To remove an accessory, pull locking
sleeve backward and pull bit forward.
All accessories should be wiped clean
after removing (Fig. 4).
Assembly
Disconnect battery pack from tool or place the switch in the locked or
off position before making any assembly, adjustments or changing
until it locks
and undamaged
Accessories may be
hot after use. Avoid
BATTERY
PACK
FIG. 3
DUST
SHIELD
FIG. 4
LOCKING
SLEEVE
-10-
FIG. 2
BATTERY
PACK
RELEASE
BUTTON