Wheel Installation; Battery - Yamaha VIKING YXM70VPXG Owner's Manual

EBU33030

Wheel installation

1. Install the wheel and the nuts.
TIP
For YXM70VPXG / YXM70VPHG: tapered
nuts are used for both the front and rear
wheels. Install the nuts with their tapered side
towards the wheel.
YXM70VPXG / YXM70VPHG
1. Tapered nut
2. Lower the vehicle so that the wheel is on
the ground.
3. Tighten the wheel nuts in a crisscross
pattern to the specified torque.
EWB03400
WARNING
Do not reverse the rims on your Yamaha
Viking to widen the track width. Installing
wheels improperly increases the risk of
wheel failure and accidents.
Tightening torques:
Front wheel nut:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Rear wheel nut:
1
75 Nm (7.5 m·kgf, 54 ft·lbf)
EBU32640

Battery

The battery is located under the hood. (See
page 8-10 for hood removal and installation
procedures.)
This model is equipped with a VRLA (Valve
Regulated Lead Acid) battery. There is no
need to check the electrolyte or to add dis-
8-41
8