Makita GSA01 Instruction Manual page 11

2. Reassemble the dust cap onto the suction inlet,
aligning the two locking tabs on the dust cap with the
guide grooves on the housing. Then turn the dust cap
clockwise to secure it in place.
3
Fig.6
► 1. Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
Installing and removing long
nozzles
Optional accessory
A set of long nozzles help clean dust out of small holes
and narrow spots. Nozzle lengths can be arranged
according to your requirements.
3
2
Fig.7
► 1. Nozzle 13 2. Long nozzle R 3. Long nozzle F
4
1
1
1. Insert the long nozzle R through the air hole of the
nozzle 13 from back to front. Pass it though until the
nozzle 13 secures in place at the rear end of the long
nozzle R.
1
2
Fig.8
► 1. Nozzle 13 2. Long nozzle R
2.
Place the long nozzle F over the front end of the
long nozzle R. Hand screw the long nozzle F until you
find it roughly tightened, then re-tighten it further until it
is secured with a click.
Fig.9
► 1. Long nozzle F 2. Long nozzle R
11 ENGLISH
1
2
2