Table of Contents
Advertisement
PULLY AND DISC CENTER HOLE ALIGNMENT
Cam
(1) Rotate the cam and adjust to the
position shown in the figure.
(2) Check that the state is as shown
in the figure.
Disc
Note: The disc should not
be fixed.
(3) Remove the Magnet assembly.
Bracket
(BU adjustment)
Magnet assembly
0.5 - 2mm
Base unit
Holder (disc A)
Magnet assembly
Cam
Base unit
Fixed screw
Loosen the fixed screw by 60° to 90°, and move and adjust the
bracket (BU adjustment) up and down using a tapering screwdriver
so that the positions of the disc hole and disc pulley become A=B
or between A:B=2:1 and 1:2.
– 17 –
Disc pulley
Disc hole
A
B
Bracket
(BU adjustment)
Tapering screwdriver
Advertisement
Table of Contents
