Sony XAV-AX6000 Operating Instructions Manual page 13

Using the steering wheel remote
control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1  is
required before use.
1
Select [Settings]  [System]  [Steering
Wheel Settings].
2
Set the [Custom] switch to [On].
You can make the registration to enable the
steering wheel remote control.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable
RC-SR1 
REMOTE IN

Black

Green

Brown
• Refer to the support site for details, then connect
each lead properly to the appropriate leads.
Making an improper connection may damage the
unit.
URL: https://www.sony-asia.com/support
• Consulting the dealer or an experienced
technician for help is recommended.
When using an adaptor for the steering wheel
remote control
Depending on the type of car, use an adaptor for
the steering wheel remote control (not supplied).
1
Select [Settings]  [System]  [Steering
Wheel Settings].
2
Set the [Custom] switch to [Off].
The adaptor for the steering wheel remote
control is enabled.
Using a USB device and/or an HDMI
device
Installation of the USB Type-C extension cable 
and/or an HDMI cable (HDMI Type-D or Micro-
HDMI) (not supplied) is required before use.
1
2
GND
Input 1
Input 2
3
4
Connect the USB Type-C extension cable 
to the USB port and/or an HDMI cable (not
supplied) to the HDMI terminal at the back
panel of the unit.
Pass the cable tie  through the cable
holder, then tie cable tie  around the USB
Type-C extension cable  and/or HDMI
cable (not supplied).
The USB Type-C extension cable  and HDMI
cable (not supplied) are secured to the unit.

* HDMI cable (HDMI Type-D or Micro-HDMI) (not
supplied)
Connect the installed USB Type-C extension
cable  to a USB device and/or HDMI cable
to an HDMI device.
Press HOME, then touch [USB] or [HDMI].
*

13
GB