Cisco PA-T3 Installation And Configuration Manual page 59

Step 3
Step 4
Step 5
Step 6
If the interface is down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the network interface is properly connected and terminated. If
you still have problems bringing the interface up, ask a service representative for assistance.
Using show Commands to Display Interface and System Information
For a Cisco 7100 series, Cisco 7200 series, or Cisco uBR7200 series router, to display information
about a specific interface, use the show interfaces command with the interface type and port address
in the format show interfaces [type slot/port].
Using show Commands to Display Interface and System Information
Specify one of the new interfaces:
•
For Cisco 7100 series, Cisco 7200 series, and Cisco uBR7200 series routers, specify
one of the new interfaces with the show interfaces type port adapter slot/interface
command, and verify that the first line of the display specifies the interface with the
correct slot number. Also verify that the interface and line protocol are in the correct
state: up or down.
•
For a VIP2, specify one of the new interfaces with the show interfaces type slot/port
adapter/interface command, and verify that the first line of the display specifies the
interface with the correct slot number. Also verify that the interface and line protocol
are in the correct state: up or down.
•
For a Catalyst RSM/VIP2, specify one of the new interfaces with the show interfaces
port adapter/interface command, and verify that the first line of the display specifies
the interface with the correct slot number. Also verify that the interface and line
protocol are in the correct state: up or down.
Specify the new serial interface:
•
For Cisco 7100 series, Cisco 7200 series, Cisco uBR7200 series routers, specify the
new serial interface with the show controllers serial port adapter slot
number/interface port number command, and verify that the first line of the display
specifies the interface with the correct slot number.
•
For a VIP2, specify information that is specific to the new serial interface with the
show controllers serial slot/port adapter/interface command, and verify that the first
line of the display specifies the interface with the correct slot number.
•
For a Catalyst RSM/VIP2, specify information that is specific to the new serial
interface with the show controllers serial port adapter/interface command, and
verify that the first line of the display specifies the interface with the correct slot
number.
Display the protocols configured for the entire system and for the specific interfaces with
the show protocols command. If necessary, return to configuration mode to add or
remove protocol routing on the system or on specific interfaces.
Display the running configuration file with the show running-config command. Display
the configuration stored in NVRAM using the show startup-config command. Verify
that the configuration is accurate for the system and each interface.
Configuring the PA-T3 Interfaces 8-15