Table of Contents
Advertisement
Performing a Basic Configuration
For complete descriptions of software configuration commands, refer to the publications listed in the
"Related Documentation" section on page vi.
Performing a Basic Configuration
The following steps make up a basic interface configuration for the PA-T3 serial port adapter. Press
the Return key after each step unless otherwise noted. At any time you can exit the privileged level
and return to the user level by entering disable at the prompt:
router# disable
router>
Step 1
Step 2
8-10
PA-T3 Serial Port Adapter Installation and Configuration
The example that follows is for a VIP2:
Router(config)# interface serial 1/1/0
Router(config-if)# no shutdown
Ctrl-Z
Router#
Router# copy running-config startup-config
[OK]
Router# show interfaces serial 1/1/0
Serial 1/1/0 is up, line protocol is up
Hardware is M1T-T3 pa
[display text omitted]
The example that follows is for a Catalyst RSM/VIP2:
Router(config)# interface serial 1/0
Router(config-if)# no shutdown
Ctrl-Z
Router#
Router# copy running-config startup-config
[OK]
Router# show interfaces serial 1/0
Serial 1/0 is up, line protocol is up
Hardware is M1T-T3 pa
[display text omitted]
At the privileged-level prompt, enter configuration mode and specify that the
console terminal is the source of the configuration subcommands:
router# configure terminal
Enter configuration commands, one per line.
router(config)#
Specify the interface to configure:
•
For a Cisco 7200 series, Cisco 7100 series, or Cisco uBR7200 series router, specify
the interface to configure by entering the subcommand interface serial followed by
the slot/port (port adapter slot number and interface port number). The example that
follows is for the interface of the port adapter in slot 3:
router(config)# interface serial 3/0
End with CNTL/Z.
Advertisement
Table of Contents
