Cisco PA-T3 Installation And Configuration Manual page 43

Figure 6-6 Placing the Port Adapter Retention Clip in the Locked
Position—Cisco uBR7246 Shown
Port adapters
•
For a Cisco uBR7223, place the port adapter lever in the locked position.
(See Figure 6-7.)
Figure 6-7 Placing the Port Adapter Lever in the Locked
Position—Cisco uBR7223 Shown
Port adapters
Note If the port adapter lever does not move to the locked position, the port adapter is
not completely seated in the midplane. Carefully pull the port adapter halfway out of the
slot, reinsert it, and move the port adapter lever to the locked position.
This completes the procedure for installing a port adapter in a Cisco uBR7200 series router. Proceed
to Chapter 8, "Configuring the PA-T3 Interfaces," for information on how to configure your port
adapter interfaces.
Port adapter
retention clip in
locked position
Port adapter
lever in locked
position
Cisco uBR7200 Series and the PA-T3 Port Adapter 6-5
Installing a Port Adapter