NEC ITY-6D Start Manual page 8

4.
Adjust the legs to the desired height (The upper they are, the
lower the phone becomes).
First Level
Attach the Handset
Please follow the diagram to attach the handset.
1.
Insert the coiled cord plug into the HANDSET connector on the back of
the phone until it sounds a click.
2.
Thread the coiled cord through the groove, as shown in the figure below.
Figure 5: Thread the coiled cord through the groove
Connect LAN cable to the Phone
A 10 BASE-T/100 BASE-T/TX LAN cable (Straight) is needed to connect
the phone to network.
1.
Connect the 10 BASE-T/100 BASE-T/TX LAN cable to the LAN
port on the phone and to an open port on a device such as a Hub
or PoE (Power Over Ethernet) switch on the local area network.
Second Level
Figure 4: Adjust the legs
3