Connecting And Checking Vision Sensor And Robot Controller - Omron Vision Sensor FH Series Connection Manual

3.2.

Connecting and Checking Vision Sensor and Robot Controller

Follow the procedures below to connect the Vision Sensor and the robot controller
and to check the connection status.
3.2.1. Verifying Ethernet Communication (FH Series Vision Sensor)
(Operation of the Vision
Sensor)
Move the mouse cursor to
lower left of the window to
display [Start]. Select [Start］
- [All Programs] -
[Accessories] - [Command
1
Prompt] to launch [Command
Prompt].
(Operation of the Vision
Sensor)
Execute PING command to
the IP address of the robot
2
controller.
(Operation of the Vision
Sensor)
When 32-byte data could be
successfully sent/received
four times as shown in the
3
figure on the right, that
means that the
communications have been
established and the wiring and
settings of Ethernet is
correctly done.
20