Table of Contents
Advertisement
Install Cisco NCS 1000 32-Channel Mux/Demux Patch Panel
Step 3
To connect and secure the inventory USB Type A plug connector to the inventory USB Type A receptacle
connector, perform the following:
a) Route the inventory USB cable through the left fiber holder clip from NCS 1010 EITU.
b) Connect the USB Type A plug connector to the USB Type A receptacle connector.
c) Tighten the captive screw on top of the USB connector to secure the USB plug.
Figure 8: Connecting USB Cable
1
2
d) (Optional) Secure the USB cable with a tie-wrap at one of the three available locations on the mux/demux
patch panel.
Note
USB 3.0 Cable
USB 3.0 Cable Screw
Perform Step d if you are routing the USB cable to the right side of the mux/demux patch panel
to the NCS 1010 EITU.
Install and Route Fiber-Optic and USB Cables
Install Cisco NCS 1000 32-Channel Mux/Demux Patch Panel
11
Advertisement
Table of Contents
