Information About Configuring Cisco Unified Meetingplace H.323/Sip Ip Gateway Software Release 5.2.1 - Cisco Unified MeetingPlace H.323/SIP Administrator's Manual

Information About Configuring Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1

If you are using an IP PBX that runs standard H.323 or SIP call control, see the
Note
Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1" section on page 3-3
required system settings and see your IP PBX documentation for information about how to configure
those settings.
Table 3-1
Table 3-1
Setting
General Settings
Max Number of
Callers
Outdial Protocol
Verbose Logging
H.323 Settings
Enabled
Max Number of
Callers
E.164 Address
H323 ID
Gateway Address and
Gateway Port
Use Gatekeeper
Gatekeeper Address
and Gatekeeper Port
Administrator Guide for Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1
3-2
Chapter 3 Configuring Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1
describes the Release 5.2.1 Management Console fields and lists the default settings.
Cisco Unified MeetingPlace H.323/SIP IP Gateway Software Release 5.2.1 Management
Console Fields and Default Settings
Description
Maximum number of callers Release 5.2.1 will accept. This
maximum number can be a combination of H.323 and SIP
callers.
Controls whether outdials from the IP-gateway server are
placed by using H.323 or SIP.
In mixed H.323-SIP, call-control environments, you
Note
must select one protocol for outdials; otherwise, the
default protocol will be used.
Sets the level of logging information.
Enables or disables the H.323 protocol.
Maximum number of H.323 callers Release 5.2.1 accepts.
A dialable number for the IP-gateway server.
Caller ID name that is used by Release 5.2.1.
IP address and port number of the server responsible for
routing H.323 calls. Outdials using H.323 are directed to this
IP address and port if an H.323 gatekeeper is not used.
You must enter this gateway information if you are
Note
using H.323 without a gatekeeper.
Enables the IP-gateway server to register with an H.323
gatekeeper.
IP address and port number of the H.323 gatekeeper. If an
H.323 gatekeeper is used, Release 5.2.1 registers with the
server and directs H.323 outdials to the server.
If using an H.323 gatekeeper, ensure that your system
Note
allows traffic to pass through ports 1024-65535
because MeetingPlace H.323/SIP IPGW uses these
ports for dynamic TCP and UDP traffic.
"How to Configure
for the
Default
960
H.323
Normal
Yes
960
—
MeetingPlace
Address: —
Port: 1720
No
Address: —
Port: 1719
OL-6571-02