Table of Contents
Advertisement
STEP 3:
With the engine running, pull trigger to operate
unit.
Liquid detergent is drawn into the unit and
mixed with water.
Apply detergent to work area.
Do not allow detergent to dry on surface.
CAUTION
This unit has been designed for use with cleaning
detergents recommended by the manufacturer.
The use of other cleaning detergent may affect the
operation of the machine and void the warranty.
Always Use Kärcher Detergent for Best Results
Kärcher biodegradable detergents are specially
formulated to protect the environment and your
pressure washer. The special formula won`t clog
the suction tube fi lter and will protect the internal
parts of the pressure washer for a longer life. For
Kärcher Detergents, check your retailer or visit
our website:
www.karcherresidential.com
STEP 1:
Move the engine stop switch to the OFF position.
For engine details see engine manual.
STEP 1:
If detergents have been used, remove deter-
gent suction tube from container and insert
into 1 gallon of fresh water.
Siphon water at low pressure for one minute
to clear the line of residual detergent.
STEP 2:
Move the engine stop switch to the OFF posi-
tion. Close the fuel valve.
STEP 3:
Turn off the water source.
STEP 4:
Press trigger to release water pressure.
10 English
WORKING WITH DETERGENTS
Detergents
TAKING A BREAK ...fi ve minutes or more
SHUTTING DOWN & CLEAN-UP
STEP 4:
Always draw fresh water through the deter-
gent suction tube when the cleaning job is
done, to rinse/fl ush any remaining detergents
from the injection system.
For best results see Cleaning Tips for specifi c
information on how to clean different surfaces.
CAUTION
Never use:
–
Bleach, chlorine products or other corrosive
chemicals
–
Liquids containing solvents (i.e., paint thin-
ners, gasoline, oils.)
–
Tri-sodium phosphate products
–
Ammonia products
–
Acid-based products
These chemicals will harm the unit and will damage
the surface being cleaned.
Use of these items will void the warranty.
STEP 2:
Release trigger and engage safety lock.
STEP 5:
Release trigger and engage gun safety lock.
STEP 6:
Disconnect the garden hose from the water
inlet on the unit.
STEP 7:
Disconnect the high pressure hose from the
high pressure outlet. Store the high pressure
hose in the nozzle holder assembly.
Advertisement
Table of Contents
