DeWalt DW059 Instructions Manual page 36

EN GLI SH
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle as shown.
Switching On and Off (fi g. A)
• To run the tool, press the on/off switch (1).
– To select forward rotation, press the lower
part of the switch.
– To select reverse rotation, press the upper
part of the switch.
• To stop the tool, release the switch.
WARNING: Always wait until the motor
has come to a complete standstill
before changing the direction of rotation.
Screwdriving or Nutsetting (fi g. A)
• Select the appropriate socket for the screw or
nut to be driven.
• Select forward or reverse rotation as described
above.
• Hold the tool in line with the fastener.
• After tightening, check torque with a torque
wrench.
Tightening Time
This tool tightens most fasteners in few seconds.
The proper tightening time in relation to torque must
be determined by experience.
Use only dedicated impact accessories with your
tool.
Consult your dealer for further information on the
appropriate accessories.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger is not serviceable. There are no
serviceable parts inside the charger.
34
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
WALT, have
E