Removing The Bezel And Cover - Cisco Engine 611 Installation Manual

Removing the Bezel and Cover

Removing the Bezel and Cover
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
To remove the bezel and cover, follow these steps:
Review the information in the
Step 1
Power down the device and all attached devices. Disconnect the power cord and all external cables.
Step 2
Remove the bezel as shown in
Step 3
a.
b.
Figure 1
To remove the cover, loosen the captive screw (labeled 1 in
Step 4
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
4
Press the release tabs on the bezel and pull the bezel away from the chassis.
Store the bezel in a safe place.
Removing the Bezel
"Protecting Against Electrostatic Discharge" section on page
Figure 1.
Figure 2) on the rear of the cover.
2.
78-17404-01