Table of Contents
Advertisement
Servicing the GPU Module
This chapter contains the following topics:
•
•
•
Servicing the GPU Module
The X10c front mezzanine GPU module contains U.2 drives, GPU cables, GPU cages, and GPU cards as
field-replaceable components.
To service these components, see the following topics:
•
•
•
Removing a Compute Node Cover
To remove the cover of the compute node, follow these steps:
Step 1
Press and hold the button down.
Step 2
While holding the back end of the cover, slide it back, then pull it up to lift the top cover off of the compute node.
By sliding the cover back, you enable the front edge to clear the metal lip on the rear of the front mezzanine module.
Replacing a GPU Cage
The GPU cage is an adapter card that provides two slots for GPUs cards. GPU cages provide the mechanical
housing for individual GPU cards. Removing the GPU cage is a prerequisite for removing or installing a GPU
card.
Servicing the GPU Module, on page 11
Recycling the PCB Assembly (PCBA), on page 26
Installing a Compute Node Cover , on page 30
Replacing a GPU Cage, on page 11
Replacing a GPU Card, on page 17
Replacing a Drive, on page 21
Cisco UCS X10c Front Mezzanine GPU Module Installation and Service Guide
3
C H A P T E R
11
Advertisement
Table of Contents
