Canon iPF9000S Troubleshooting Manual page 112

20. Imaging Failures ⑥
C1 AutoCAD (Windows only)
C2 Adobe Illustrator
C3 Other applications
C4 Main unit
Cause
Check to see if an error has been detected by running Nozzle Check Print in
C4
User mode.
C1, 2, 3 Check to see if the latest release of the service pack is installed.
C1 AutoCAD general problems
C2 Adobe Illustrator problem
C4 Underpowered HP-GL/2, HP RTL
C3 Other general application problems
C2 Postscript data (Adobe Acrobat, Illustrator, etc.)
Explanatory drawings
Normal
Missing objects
Flow 1
With AutoCAD2007 or 2007LT, install Service Pack 2
Where a large image is pasted, for example, the problem can be avoided by cutting the workload on AutoCAD
Too high image quality setting for
AutoCAD
Driver setting of A1 or higher
FineZoom set to [Auto]
Driver used
Too high print quality setting
Too large an image pasted
Not enough PC memory
*In addition to missing image, phenomena, such as "Dimmed print," "Print failure" and "Abnormal tinting (fewer colors)" might be observed.
Point to check
Defective
*For all AutoCAD programs including AutoCAD2007, there are fix patches released. Be sure to
install the latest patch as much as possible.
Choose [Properties] in the [AutoCAD Print] dialog box
Choose [Graphics] → [Raster Graphics]
Change the setting of [Raster and Shading/Rendering View Port] and move the slider to left
In the printer driver properties dialog box, choose [Layout] ⇒ [Special Settings] and change
[Set FineZoom]
*The default setting is [Auto]. Seek confirmation from the customer because the new setting
could worsen image quality.
In the printer driver properties dialog box, choose [Main] ⇒ [Advanced Settings] and
change [Print Quality] to [Draft]
Reduce the image resolution using an application, such as Photoshop, to hold the number
of pixels to 2,000,000 or below
Expand PC memory
Chapter 3 More Sophisticated Fault Isolation Tasks
Missing lines or images
3-36
Action
T03 (P4-3)
Install.
Flow 1
Flow 2
Flow 3
Flow 4
Recommend the use of
RIP.