Table of Contents
Advertisement
Available languages
Available languages
en
ENGLISH
D Hook and loop polishing felt, soft (for buffing
paint,ferrous metals and stainless steel sheets)
E Hook and loop lambswool polishing disc (for
buffing weathered paint)
F Cushioning disc with Velcro fasteners (for
sanding curved surfaces)
G Felt polishing disc with internal thread M 14
For a complete range of accessories, see
www.metabo.com or the catalogue.
11. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
A defective mains cable must be replaced only with
a special, original mains cable from metabo
available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
Observe the national regulations on
environmentally compatible disposal and on the
recycling of disused tools, packaging and
accessories.
13. Technical Specifications
Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
D
= maximum support plate diameter
max
M
= maximum torque
t, max
M
= Spindle thread
l
= Length of the sanding spindle
n*
= No-load speed (maximum speed)
I
= Current at 120 V
120 V
n
= No-load speed depending on the thumb-
S
wheel position
n
*
= Speed at rated load
N
P
= Rated input power
1
P
= Power output
2
m
= Weight without mains cable
* Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations
disappear, however, as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
10
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
=Vibration emission value (polishing)
h, P
a
=Vibration emission value (sanding
h, DS
surfaces)
K
/K
=Uncertainty (vibration)
h,P
h,DS
Typical A-effective perceived sound levels:
L
= Sound-pressure level
pa
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
Advertisement
Table of Contents
