Power-Up Procedure - Cisco AS5400 Quick Start Manual

Power-Up Procedure

Perform this procedure to power up your Cisco universal gateway and verify that it goes through its initialization and self-test.
When this is finished, the Cisco universal gateway is ready to configure.
To view the boot sequence through a terminal session, you must have a console connection to the Cisco universal
Note
gateway before it powers on. To connect to the console, refer to the "Connect a Console Terminal" section on page 15.
Move the power switch to the ON position. The system board OK LED should come on and messages will begin to appear in
your terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted
as the first command typed when the messages stop, which might cause the universal gateway to power off and
start over. It takes a few minutes for the messages to stop.
The displayed messages depend on the Cisco IOS software release and cards installed in your system. The screen
Note
displays in this section are for reference only and might not exactly reflect the messages on your console.
The messages look similar to the following:
System Bootstrap, Version 12.1(2r)XD1, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
AS5350 platform with 131072 Kbytes of main memory
Self decompressing the image : ################################################[OK]
Self decompressing the image : ################################################[OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 5350 Software (C5350-IS-M), Version 12.2(2)XA, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
TAC:Home:SW:IOS:Specials for info
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Tue 26-Jun-01 23:47 by hwcheng
Image text-base: 0x600089C8, data-base: 0x61000000
cisco AS5350 (R7K) processor (revision O) with 131072K/65536K bytes of memory.
Processor board ID JAB0430086M
R7000 CPU at 250Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Last reset from IOS reload
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x32,
Board Hardware Version 3.27, Item Number 800-5171-01,
Board Revision B0, Serial Number JAB0430086M,
31