Name Of Parts - Haier AB422BCBAA User Manual

Name of Parts

13
12
11
10
9
8
7
6
5
4
3
2
1
1.ON/OFF button
Used to turn on/off unit
2.Temperature display
3.Clock display
4.Timer ON/OFF display
5.Humidity display
6.Air filter cleaning display
When there is too much dust
collected on the air inlet, the
wire controller will show
this display to remind the
user to clean the air inlet.
After cleaning and installation,
*
just press the air filter reset button.
7.Super/Soft operation display
8.Fan speed display
Low Fan Med Fan High Fan Auto
9.Auto Swing display
10.Health state display
11.Fresh air state display
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method
of calibration is:
1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.
2.Press * or * to adjust time. For each press, the time will increase or
minute. If depressing the button, the time will increase or decrease
3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing, the
clock will begin to work.
4
14 15 16 17 18
MODE FAN
AUTO
TEMP
CLOCK
SET TIMER
ROOM
FILTER RESET
ON/OFF
12.Humidifying state display
13.Sleep state display
14.Network control display
15.Working mode display
Working Auto
mode operation
Wire
controller
16.Electric heating display
Used to set working mode:
17.Operation mode button
Auto, Cooling, Dehumidifying,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
Auto
19.Swing button
Used to set Auto Swing or
Fixed air sending direction
20.Temperature Setting button
Used to set temperature,
temperature range: 16*~30*
19
SWING
20
21
SET
22
SLEEP
23
24
RESET
25
26
27
28
Cooling Dehumidifying Heating
operation operation operation
Wire Controller
21.Clock button
Used to calibrate the time of
timer and clock
22.Setting button
Used to confirm the time
of timer and clock
23.Sleep button
Used to set Sleep state or
Power Failure Resume
Function
24.Time Adjusting button
Used to adjust the time of
timer and clock
25.Reset button
When the wire controller
a p p e a r s a b n o r m a l
condition, use a sharp-
Fan
pointed article to press
operation
this button to make the
wire controller resume
normal
26.Air Filter Reset button
After cleaning the air inlet,
press this button, the unit
can start to operate
27.Timer button
Used to set the mode of
timer
28.Lock state display
Note:
This model does not
have the following
related display and
function
* * 10 11 12 28
*
decrease 1
*
rapidly.