Haier AB182ACAEA Operation And Installation Manual page 29

Installation Procedure
2. Mounting on high ceiling
(1) Ornament panel can be mounted on ceiling as high as 3 m.
(2) Please install pad as accessary.
Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4)
1
Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6.
2
Cutting line
a
50
Fig. 4
Part a of the pad
Swing flap motor
(3)Wiring on ornament panel
Connecting of wiring of the swing
flap motor on ornament panel. (2 places)
(Refer to Fit . 10)
If connecting is not made, error code
(A7) appears on remote controller. So,
make proper connecting.
3. Install ornament panel on indoor unit.
For indoor unit installation, please
refer to Installation Manual.
(1)
As shown in Fig . 7, match the position of swing
flap motor with that of the indoor unit piping hole ,
so that ormament panel can be placed on to indoor
unit.
(2)
Installation of ornament panel
Place the holding ring on swing flao motor side
1
teporarily on hooks of the indoor unit. (2 pcs)
Put the other two holding rings on the hooks at both
2
side of the indoor unit. (Care should be taken not to
push wiring of swing flap motor into seals).
Screw in all 4 screws under holding ring for about
3
15mm. (Pancl will rise).
4 Adjust the ornament panel as per Fig. 7 to cover
opening on the ceiling.
5 Tighten screws to redrce the thickness of seals
between ornament and indoor unit to 5-8mm.
If screws are not tighten tight,
problems in Fig, 8 might occur.
Tighten screws properly.
Gas leakage.
Gas leakage
from roof.
Mist exists and drop down.
Contamination
Fig. 8
b
100
Fig. 5
Caution
If there are still space
after tightening of screws,
please readjust the height
of indoor unit.
(Refer to Fig. 9)
Leave no space.
Place it on the frame.
Part a of the pad
Side of indoor unit
2
Swing flap motor
3
4
Fig. 7
Indoor unit
Ceiling material
If indoor unit is at horizontal level and water
drainage is smooth, then, indoor unit height
can be adjusted throrgh holes at corners of
ornament panel.
Fig. 9
27
Leave no space.
Fig. 6
Side of ornament panel
Fig. 10
Wiring diagram
Holding ring 1
Piping hole position
2
Seal
5 _ 8mm
Ornament panel
Hook