Table of Contents
Advertisement
Getting started
Chapter 4
Getting started
Changing the TV format setting
If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
1
Switch the system into standby.
2
While holding down the TUNE + on the
front panel, and hold the STANDBY/ON for
about two seconds.
The display shows the new setting (PAL or
NTSC).
Changing the frequency step
If you find that you can't tune into stations
successfully, the frequency step may not be
suitable for your country/region. Here's how to
switch the setting:
1
Switch the system into standby.
2
While holding down the TUNE – on the
front panel, and hold the STANDBY/ON for
about two seconds.
The channel tuning step alternates between
100K STEP and 50K STEP each time you do this.
Automatically setting up for
surround sound (MCACC)
The Auto Multi-Channel Acoustic Calibration
(MCACC) setup measures the acoustic
characteristics of your listening area, taking
into account ambient noise, speaker size and
distance, and tests for both channel delay and
channel level. After you have set up the
microphone provided with your system, the
system uses the information from a series of
test tones to optimize the speaker settings and
equalization for your particular room.
Important
• The Auto MCACC Setup will overwrite any
existing speaker settings you've made.
• Before using the Auto MCACC Setup, the
iPod USB function should not be selected
as an input source.
Caution
• The test tones used in the Auto MCACC
Setup are output at high volume.
SYSTEM
INPUT SELECT
SOURCE
SYSTEM
TV CONTROL
INPUT
CH
1
Connect the microphone to the MCACC
SETUP MIC jack on the rear panel.
Make sure there are no obstacles between the
speakers and the microphone.
MASTER
AUDIO
TUNER EDIT
PARAMETER
TOOLS
VOLUME
MENU
TOP
MENU
ENTER
HOME
MENU
SETUP
iPod CTRL
RETURN
ST/MONO
PTY SEARCH
04
33
En
Advertisement
Chapters
Table of Contents
