Fig. 2; Fig. 3 - Husqvarna RS 8500 D Operator's Manual

Table of Contents

Advertisement

FiG. 2

2A.
BlADe SHAFT BolT oR nUT: Use to tighten the
outer flange against the diamond blade.
2B.
oUTeR FlAnGe: Use to hold the diamond blade
in position.
2C.
oUTeR FlAnGe ARBoR: Use to support the
diamond blade.
2D.
loCkinG Pin: Use to prevent the diamond blade
from rotating on the shaft during operation.
2e.
DiAmonD BlADe: Use as the cutting tool for
concrete and asphalt surfaces.
2F.
inneR FlAnGe: Inside support used to hold the
diamond blade in position.
2i.
BlADe SHAFT: Supports the blade flanges
and blade.
30

FiG. 3

3A.
WATeR VAlVe: Use to control the water supply
to the diamond blade.
3B.
liFTinG BAil: The saw can be lifted from
this point.
3C.
FRonT GUiDe: Use to locate the path of the
diamond blade on the cutting line.
3D.
WATeR JeT, ReAR PoinTeR: Adjust to flush
slurry out of cut.

Advertisement

Table of Contents
loading

Table of Contents