Horizontal Rectangle Size (Decipoints) Command; Horizontal Rectangle Size (Pcl Units) Command - HP PCL 5 Reference Manual

Horizontal Rectangle Size (Decipoints) Command

This Horizontal Rectangle Size command specifies the rectangle
width in decipoints.
Default
Range
The printer converts the specified width to printer dots by rounding
up to an integral number of dots. For example, 5 decipoints, which
corresponds to 2.08 dots in 300 dpi mode, is converted to 3 dots.

Horizontal Rectangle Size (PCL Units) Command

This Horizontal Rectangle Size command specifies the rectangle
width in PCL Units.
Default
Range
For example, if the unit of measure is set to 300 units-per-inch, to
specify a two-inch wide rectangle, send the command:
The same command specifies a one-inch wide rectangle if the unit of
measure is set to 600 units-per-inch.
Note The number of units-per-inch used in PCL dot moves is determined
by the current setting of the Unit of Measure command (see "Unit of
Measure Command" in Chapter 4).
EN
E
* c # H
C
# =Number of decipoints (1/720 inch)
= 0
= 0 - 32767 (valid to 4 decimal places)
E
* c # A
C
# =Number of PCL Units
= 0
= 0 - 32767
Horizontal Rectangle Size (Decipoints) Command 14-3
E
*c600A
C