Table of Contents
Advertisement
Software Release: [TBD]
MPC-10 Specifications
Interface
Display:
Monochrome HR-TFT, 2.7 in. / 68mm, WQVGA (400 x 240 pixels)
(3) LEDs: green (mode), yellow (warning) and red (shutdown)
Operator controls:
(11) Raised silicon keypads, tactile feedback
Power Supply
Operating Voltage: 8-32 VDC, reverse battery polarity and load-dump protected
Cranking Power Holdup: 0 VDC up to 50mS (also good for brownout/blackout instances)
Power Consumption:
18W max without two 1A High-side FETs active,
146W max with two 1A High-side FETs active
Inputs
(5) Digital, configurable (active on High, Low, Open)
(3) Analog, configurable (4-20mA, 0-5V, resistive or digital ground)
(1) Frequency, supporting:
Magnetic Pickup (30 Hz – 10 kHz, 2.0 VAC – 120 VAC) &
Engine Alternator (30 Hz – 10 kHz, 4.5 VRMS – 90 VRMS)
Outputs
(3) Relay:
(1) SPDT
(2) B+ out
(2) Low-side FET (-DC), 1A
(2) High-side FET (+DC), 1A
(1) Dedicated Alternator Excitation, +DC, 1A
Communications
(1) CAN: J1939
(1) RS485: Modbus RTU
(1) USB: 2.0B (Supported for quick programming)
Mating Connectors
12 Position, DT06-12SA PO12 (Gray)
12 Position, DT06-12SB-PO12 (Black)
12 Position, DT06-12SC-PO12 (Green)
Physical / Environmental
Enclosure Material: Polycarbonate / ABS
Dimensions (WxHxD): 9.59 x 7.34 x 5.20 in. (243.48 x 186.5 x 132.23 mm)
Weight: 4 lbs (1.8 kg)
IP Rating: IP69K & IP67 front and back, IP66 panel seal when used with accessory gasket
Operating & Storage Temperature: -40° to +85° C (-40° to +185° F)
Vibration: 7.86 Grms (5-2000 Hz), 3-axis random
Shock: ±50G, 3 axis
Emissions & Immunity: SAE J1113, 2014/30/EU & 2014/35/EU
Section 40
2018-09-18
45
00-02-1167
Advertisement
Table of Contents
