Care And Maintenance - Vinotemp VT-32TSFE-SM Owner's Manual

33 bottles
Hide thumbs Also See for VT-32TSFE-SM:
Table of Contents

Advertisement

CLEANING YOUR WINE COOLER
IMPORTANT: Always unplug the unit before cleaning or performing maintenance. Never use harsh
cleansers or scouring pads to clean any part of the unit.
Turn off the power, unplug the appliance, and remove all items including shelves.
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
Wash the shelves with a mild detergent solution.
Wring excess water out of the sponge or cloth before cleaning control panels or any electrical
parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
DEFROSTING
The evaporator behind the rear wall of the unit defrosts automatically. The condensate collects in the
drainage channel behind the rear wall of the unit, and flows through the drainage hole into the drip
tray by the compressor where it evaporates.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance. If the power is off for an extended period of time, proper steps should be taken to protect
your wine.
INACTIVITY
If the unit will not be used for a period of less than three weeks, leave the cooler operating. If the
period of inactivity is several months, remove all items and turn the unit off. Clean and dry the interior
thoroughly. Leave the door open slightly to prevent any possible moisture build-up.
MOVING YOUR WINE COOLER
Before moving your wine cooler, first be sure to remove all items from the cooler.
• Securely tape down any loose items, such as shelves, inside the unit.
• Turn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Ensure that the unit stays securely in the upright position during transportation. Protect the
outside of the appliance with a blanket or similar item.
ENERGY SAVING TIPS
• The unit should be located in the coolest area of the room away from heat sources or direct
sunlight.
• Ensure that the unit has proper allowances on all sides for proper ventilation. Never cover any
air vents.
• Only open the cooler door for as long as necessary. Frequent opening of the door will affect
internal temperature.
12

CARE AND MAINTENANCE

W W W . V I N O T E M P . C O M

Advertisement

Table of Contents
loading

Table of Contents