Updating The Software - Bosch WTWH7568SN Installation And Operating Instructions Manual

Home Connect
en
Turn the programme selector to
3.
position 5.
§"à (reset network settings) will
appear on the display.
Press (Start/Pause) A.
4.
¢"à (yes) will appear on the display.
Press (Start/Pause) A to confirm.
5.
"Ÿš (end) will appear on the
display.The network settings have now
been reset. Your appliance is no longer
connected to your home network or the
Home Connect app.
Press (Remote Start) } briefly to
6.
exit the Home Connect settings.
Notes
If the network settings could not be
■
reset, "§§ (fault) will appear on the
display.
If you want to operate the appliance
■
via the Home Connect app again,
you will need to reconnect it to your
home network and to the
Home Connect app either
automatically or manually.

Updating the software

You can update the Home Connect
software on your appliance.Whenever a
new update is available, —˜š (update)
will appear on the display.
You can install the update directly via
the message on the display or,
alternatively, via the appliance settings.
36
Switch on the appliance.
1.
Press and hold (Remote Start) } for
2.
at least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Turn the programme selector to
3.
position 6.
—˜š (update) will appear on the
display.
(Start/Pause) A will flash if a software
update is available.
Press (Start/Pause) A.
4.
¢"à (yes) will appear on the display.
Press (Start/Pause) A to confirm.
5.
Update installation will now start. This
process may take several minutes. Do
not switch the appliance off while
updates are being installed.
Press (Remote Start) } briefly to
6.
exit the Home Connect settings.