5
Repeat the steps above to program another device for any of the remaining
®
HomeLink
■
Programming a rolling code system
Two or more people may be necessary to complete rolling code programming.
3
Press and hold the desired HomeLink
release it. Repeat this sequence (press/hold/release) up to 3 times to complete pro-
gramming.
If the garage door opener motor operates when the HomeLink
garage door opener motor recognizes the HomeLink
Vehicles with auto anti-glare inside rear view mirror
85
buttons.
1
Locate the "Learn" or "Smart" button
on the garage door opener motor in
the garage.
This button can usually be found where
the hanging antenna wire is attached to
the unit. The name and color of the but-
ton may vary by manufacturer. Refer to
the owner's manual supplied with the
garage door opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
3
Perform
performing
®
button (inside the vehicle) for 2 seconds and
®
signal.
within 30 seconds after
2
.
®
button is pressed, the