Daewoo DWF-5510 Service Manual page 7

5 . D IRECTION S FOR IN STALLATION AN D U SE
In s t a l l in g Pl a c e
Install the washer on a horizon-
tal solid floor. If the washer is
installed on an unsuitable floor,
it could make considerable
noise and vibration.
In s t al l at io n O f T h e U n d er B as e C o v er [Op t i o n ]
§
- D W F - 5 5 1 0 / 5 5 1 1 / 5 0 1 0 / 6 0 1 1
Before installing your
1
washer, remove the
pad from the bottom
of the cabinet. Then,
separate under cover
from rear side of cab-
inet by unscrewing
and insert it into the
base.
- D W F - 5 5 2 0 / 5 5 2 1 / 6 0 2 0 / 6 0 2 1
There is under-base
1
cover in the tub of the
washer. Put out and
draw it in its proper
site. (See picture)
H o w T o In s t a l l O n A n In c l in e d P l a c e
§
1
Horizon
Setting
After controlling the height
by turning the adjustable
leg, let the washer put
down to the ground.
8 DIRECTIONS
Keep the machine body more
than 25cm apart from the wall
surface. It will make easy clean-
ing the drain filter which is
equipped at the back side of it.
And if it comes into contract
vibration may occur.
10Cm
SCREW
2
Check the Horizon
Status
Check the position of tub above
the center of the washer.
Never install in these places
The place where it would be
¡
exposed to direct sunlight.
The place nearby a heater or heat
¡
appliance.
The place where it would be sup-
¡
posed to be frozen in winter.
The kitchen with coal gas and a
¡
damp place like a bathroom.
Push the under-base
2
cover into the end, which
decrease the noise made
by this washer.
Push the under-base
2
cover into the end, which
decrease the noise made
by this washer.
NOTES
The openings must not
be obstructed by carpet-
ing when the washing
machine is installed on a
carpeted floor.