Daewoo DWF-5510 Service Manual page 11

A u t o ma t ic U n b a l a n c e A d j u s t me n t
This system is to prevent abnormal vibration during intermittent spin and spin process.
FUNCTIONAL PRINCIPLE
When the lid is closed, the safety switch
1
contact is "ON" position.
In case that wash loads get uneven during
2
spin, the outer tub hits the safety switch
due to the serious vibration, and the spin
process is interrupted.
In case that P.C.B. ASS'Y gets "OFF" signal
3
from the safety switch, spin process are
stopped and rinse process is started auto-
matically by P.C.B. ASS'Y.
If the safety switch is operated due to the
4
unbalance of the tub, the program is
stopped and the alarm is given.
NOTES
The alarm finished when you close the lid after opening
it. Check the unbalance of the wash load and the instal-
lation condition.
C ir c u l a t in g -Wa t e r C o u r s e a n d L in t F il t e r
CIRCULATING-WATER
The washing and rinsing effects have been
improved by adopting the water system in
which water in the tub is circulated in a
designed pattern.
When the pulsator rotates during the washing
or rinsing process, the water below the pul-
sator vanes creates a water currents as shown
in figure.
The water is then discharged from the upper
part of the tub through the water channel.
About 40 L/min. water is circulated at the 'high'
water level, standard wash load and standard
water currents.
14 EXPLAN ATION
Position of
unbalanced load ( OFF)
Filter
Water
channel
Pulsator
Contact of safety switch Lid closing
Lid opening
Contact lever A
Normal (ON)
Tub
Outer tub