HP Visualize J5000 Upgrade Instructions page 24

System Board Removal/Replacement
Reinserting the Memory Card(s) (DIMMs)
Reinserting the Memory Card(s) (DIMMs)
1. Refer to the label in the system for correct installation sequence.
2. Make sure the ejector tabs are angled outward. Next, align the
notched edge of the memory card with its slot. Insert the memory
card and firmly and evenly push down on each side to lock it into
place. the ejector tabs will angle upward as the memory card is
inserted.
3. Make sure the ejector tabs are angled outward. Next, align the
notched edge of the memory card with its slot. Insert the memory
card and firmly and evenly push down on each side to lock it into
place. the ejector tabs will angle upward as the memory card is
inserted.
4. Visually inspect and confirm the connection between the memory
card and the system board.
5. Repeat steps 1 and 2 for all memory cards.
24 Chapter 2